Claw InstallationUpdated 10 days ago

Thank you for purchasing our holster claw! Here's a breakdown of what's included in your claw kit:

- 2 pads (one thick and one thin)

- 1 lock washer

- 1 double-ended back post

- 1 thick rubber washer

- 2 small screws

- The claw itself

Here are the steps to get started:

1. Disassemble the Retention Component of Your Holster: Begin by taking apart the retention part of your holster to prepare for the installation of the claw.

2. Determine the Desired Push: Decide how much push you need against your belt. Adjust the angle of the claw accordingly:

   - Aggressive Push: Attach the claw to the front of the holster using the thick pad.

   - Moderate Push: Attach the claw to the front of the holster using the thin pad.

   - Lite Push: Attach the claw to the back of the holster using the thick pad.

   - Minimal Push: Attach the claw to the back of the holster using the thin pad.

3. Install the Claw:

   - Attach the short end of the double-ended back post to the thick washer.

   - Insert the long end of the back post into the side of the holster where you want to mount the claw.

   - Place the lock washer on the back post, add the claw on top, and secure it with one of the provided screws. One of the great features of our claw is that tightening it will not affect the retention settings of your holster.

   - Press the selected pad into the claw until it clicks into place.

   - Use the second screw to adjust the retention as necessary on the back of the holster.

Your holster claw is now installed and ready for use. We're confident it will enhance your holster's performance and comfort. If you have any questions or need further assistance, please don't hesitate to reach out to our customer service team here. We're here to help!